• Displays the digital Audio Bit Rate.
• Display the time.
• Display the date.
Listening to the FM Radio
1. Select the RADIO mode with the “STANDBY / FUNCTION” button, until “FM” is shown in the display.
2. For FM reception: Completely extend the telescopic antenna. Change its position to improve the reception.
3. There are two options to search for and preset radio stations.
• Automatic scan:
Important! Any preset radio stations will be overridden.
Press and hold the "AMS / MODE" button for approx.3 seconds. The system scans the entire frequency band for radio
stations. Any stations found will be preset from lowest to highest frequency.
•Manual scan for audio stations:
Briefly press the “SKIP+ / TUNING+” & “SKIP- / TUNING-” buttons, until you have found the radio station which you
are looking for. If you keep one of the buttons pressed down, the device will search to the previous, respectively next
radio station.
Preset station:
1. Press and hold the "AMS / MODE" button on unit for about 2-3 seconds to start the automatic preset process.
2. Display will show the memory sequence number and radio stations will be automatically preset into the sequence
number (Note: Each sequence number means 1 preset station while during automatic preset process.)
3. Once all the stations were automatic preset, press the “PRE. / FOLDER” button to choose preset stations.
Show FM information
Press the “INFO” button to show the following information, if broadcast by a radio station.
• Radio Text is shown by default on the display. If no information is available, [No RadioText] appears on the display.
• The program type (PTY) of the station is displayed (e.g. Pop music, news etc.). If no PTY is received, [No PTY]
appears on the display.
• Display the time. If no TIME is received, [No Time] appears on the display.
• Display the date. If no DATE is received, [No Date] appears on the display.
To Next Page
Loading...
