Denver WCT-8010 - Set Camera Mode; Format SD Card; Set Photo Size; Set Video Size

Video Size, Multi, Video Length, Delay, and Timer.
4.1.6 Set Camera Mode
There are three camera modes: Camera, Video and Camera + Video. The way to set the
camera mode is via setting menu.
The following shows how to set camera mode to Video, provided that the previous
option is Photo:
a) Press MENU to display the setting menu.
b) Press DOWN to select Mode.
c)
Press OK to select Video.
d) Press down the select switch to save the current setting.
Press MENU to cancel setting and return to info display.
4.1.7 Format SD-Card
The system will delete all images or videos stored in the SD-card after formatting, make
sure that you have made a backup of important data.
a) Press MENU to display the setting menu.
b) Press RIGHT to select System setting.
c) Press DOWN to select Format.
d) Press RIGHT to select SD Card.
e) Press down the select switch to choose Enter to enter into submenu.
f) Press down to select OK. OK will be highlighted.
g) Press OK to start formatting the SD-card. During formatting, the display screen
will show a message “Please Wait” as below.
Press MENU to cancel setting and return to info display.
Please Wait!
4.1.8 Set Photo Size
This parameter has three values: 12MP, 8MP and 5MP. The default value is 5 mega
pixels. The following shows how to set pixel size as 5M Pixel:
a) Press MENU to display the setting menu.
b) Press DOWN to select Resolution.
c)
Press OK to select 12M Pixel.
d) Press down the select switch to save the current setting, then press menu to
return to info display.
Press MENU to cancel setting and return to info display.
4.1.9 Set Video Size
This parameter also has four values: 1080P, WVGA.
The default value is 1080P,the following shows how to set 720P video size as provided
that the previous option is at WVGA:
a) Press MENU to display the setting menu.
b) Press DOWN to select Resolution.
c)
Press OK to select WVGA.
d) Press down the select switch to save the current setting, then press menu to
return to info display.
Press MENU to cancel setting and return to info display.
4.1.10
Set Date and Time
You can change the date and time of the device by setting this parameter when
necessary, e.g., after every battery change. The date format is day/month/year, the time
format is hour: minute: second. The valid value for year is between 2010 and 2050.
Provided that the date and time are needed to be set to November 15th, 2011 and half
past ten, the steps are as following:
ENG-9