Depaepe Telecom HD2000 - Page 34

HD2000 IP User Manual
Copyright © 2015 SAS HENRI DEPAEPE Page 34 of 52
Network – Basic
Options
Meaning
WAN
WAN
There HD2000IP operates in two modes:
1. DHCP mode: all the field values for the Static IP mode are not used
(even though they are still saved in the Flash memory.) The HD2000IP
acquires its IP address from the first DHCP server it discovers on its
LAN. The DHCP option is reserved for NAT router mode. To use the
PPPoE feature, set the PPPoE account settings. The HD2000IP
establishes a PPPoE session if any of the PPPoE fields are set.
2. Static IP mode: configure all of the following fields: IP address,
Subnet Mask, Default Gateway address, Primary DNS , Secondary
DNS. These fields are set to zero by default.
3. PPPoE mode :
Reply To ICMP
If set to “Yes”, the HD2000IP will respond to the PING command from
other computers, but it also is vulnerable to the DOS attack. Default is
No.
WAN Http Access
If this parameter is set to “No”, the HTML configuration update via
WAN port is disabled.
PC port
PC port
As Bridge
As Router
IP address
Subnet Mask
IP Lease Time
DHCP Server :
Port Map :