DERMAPEN HOME - Powering on the Device; Status LED and Audible Tones; Installing and Downloading the Dermapen HOME; App

17 Dermapen HOME
TM
User Manual
8.3 - POWERING ON THE DEVICE
1. Press and hold the Primary Button until the Dermapen HOME
TM
beeps. This should take around 3 seconds. The Status LED
lights blue and the Speed Indicator Ring will begin to flash.
2. Once the device is powered on, the Speed Indicator Ring and
Level Indicator Digits will be displayed. The Status LED will
light blue to indicate device is ready for normal operation.
3. Adjust the Speed Indicator Ring and Level Indicator Digits
as required.
4. Press the Primary Button once to activate Treatment Mode.
8.4 - STATUS LED AND AUDIBLE TONES
The status LED displays 3 different states:
• Blue: Normal Operation
• Orange: Attention
• Red: Critical Attention
The Dermapen HOME
TM
emits the following audible tones (beeps):
Single Beep: Indicates a button press
Double Beep: Indicates Speed/Level setting has been set, or
there is an alert requiring attention
Triple Beep: Indicates a Critical Battery Alert or Motor Error
(refer to section 11, page 26).
8.5 - INSTALLING AND DOWNLOADING THE
DERMAPEN HOME
TM
APP
1. Open the Apple or Android App Store on your compatible
smartphone.
2. Search for “Dermapen HOME”.
3. Tap the ‘Get’ or ‘Install’ button on the app page to install the
app. The App is free and will not cost any money to download
or use.