www.desatech.com
116035-01J36
TO TURN OFF GAS
TO AppLIANCE
1. Turn off wall switch.
2. Turn off all electric power to appliance if
service is to be performed.
3. Open lower louver panel.
4. Turn equipment shutoff valve clockwise
to OFF. Do not force.
5. Close lower louver panel.
OpTIONAL WIRELESS
REMOTE OpERATION
Note: The WRC receiver and hand-held
remote control kit must be purchased sepa-
rately (see Accessories, page 52). Follow
installation instructions included with the
remote control.
1. Turn equipment shutoff valve to ON posi-
tion. You can now turn burner on and off
with the-held remote unit.
IMPORTANT: Be sure to press the ON/
OFF buttons on hand-held remote control
unit for up to 3 seconds to assure proper
operation.
2. Press the ON/OFF button to turn burner
on and off.
IMPORTANT: Do not leave selector switch
in the REMOTE or ON position when the
pilot is not lit. This will drain the battery.
OpERATING OpTIONAL
THERMOSTAT
WARNING: Do not con-
Light the replace as instructed in Lighting
Instructions on page 35. Set wall thermostat
to desired temperature.
This thermostat has been electronically cali-
brated at the factory and requires no adjust-
ment or leveling.
Upon installation, thermostat must be allowed
to stabilize at room temperature for a mini-
mum of 30 minutes for proper operation.
To turn replace off, adjust thermostat to the
lowest setting and turn gas control knob back
to PILOT. The pilot will remain lit.
IMPORTANT: To turn pilot off, turn gas control
knob on heater to the OFF position.
OpERATING OpTIONAL
Locate blower controls by opening lower
louver panel on replace. Blower controls are
located on the right side of switch bracket to
the left just inside louver panel.
The BK manual blower and BKT thermostati-
cally-controlled blower have an ON setting
and an OFF setting. The blower will only run
when switch is in the ON position. In the OFF
position, blower will not operate.
Note for BKT Only: If you are using BKT
blower with optional thermostat (wall mounted
or remote control) for the replace, your re-
place and blower will not turn on and off at the
same time. The replace may run for several
minutes before blower turns on. After heater
modulates to the pilot position, the blower will
continue to run. The blower will shut off after
the rebox temperature decreases.
The blower helps distribute heated air from the
replace. Periodically check louvers of rebox
and remove any dust, dirt or other obstruc-
tions that will hinder the ow of air.
Figure 67 -
Setting the Selector Switch, Gas
Control Knob and Variable Control Knob for
Remote Operation
To Next Page
Loading...
