www.desatech.com
116035-01J38
CLEANING AND MAINTENANCE
-
(see Replacement Parts
-
If glass has been broken, carefully remove
glass door (see Removing/Replacing Glass
Door, page 30). Vacuum all glass pieces with
a shop vac.
CAUTION: Do not vacuum if
Use only the tempered glass door replace-
ment intended for this replace (see Replace-
ment Parts, page 45 for detail on ordering).
No substitutions may be made. See Remov-
ing/Replacing Glass Door, page 29 for instruc-
tions for replacing glass door.
unlatched, removed, cracked
• Remove ember material before cleaning
burners and replace when cleaning is
complete.
• Burner and controls should be cleaned
with compressed air to remove dust, dirt
or lint.
• Use a vacuum cleaner or small, soft bristled
brush to remove excess dust, dirt or lint.
GLASS DOOR
-
-
Glass must be cleaned periodically. During
start-up it is normal for condensation to form
on the inside of the glass causing lint, dust and
other airborne particles to cling to the glass
surface. During initial start-up a slight lm may
form on the glass due to paint curing. The
glass should be cleaned several times with a
non-ammonia, nonabrasive household clean-
er and warm water after the rst two weeks
of operation. Thereafter, clean the glass two
or three times during each heating season,
depending on the usage and circumstances
present. Refer to Removing/Replacing Glass
Door, page 29 of this manual when removing
glass door for cleaning.
To Next Page
Loading...
