www.desatech.com
116035-01J32
FIREPLACE INSTALLATION
Continued
Ember
Material
Ember
Tray
Figure 60 - Applying Ember Material
4. Open bag of ember materials.
5. Break apart about quarter sized pieces
and place a single layer along full length
of ember tray to hide bottom edge of base
log (see Figure 60).
6. Replace glass door and louver panels.
See Removing/Replacing Glass Door,
page 30.
OPERATION
• Do not touch any electric switch; do
Figure 61 - Control Valve
Gas Control
Knob
Variable
Control Knob
Piezo
Ignitor
FOR YOUR SAFETY
WARNING: If you do not fol-
low these instructions exactly,
-
-
WHAT TO DO IF YOU SMELL GAS
MILLIVOLT MODELS
LIGHTING
INSTRUCTIONS
1.
STOP! Read the safety information above.
2. Open lower louver panel.
3. Turn off all electric power to replace.
4. Push in gas control knob slightly and turn
clockwise to OFF (see Figure 61).
5. Wait ve (5) minutes to clear out any
gas. Then smell for gas, including near
the oor. If you smell gas, STOP! Follow
“B” in the safety information above. If you
don’t smell gas go to the next step.
6. Pilot is located by main burner and should
not require accessing for lighting.
7. Turn gas control knob counterclockwise
to PILOT.
To Next Page
Loading...
