desmon GBF-7 - Service Menu - Configuration Parameter

11 Rev 07/04/2015
1.2.
FAILURE CODE DETAILS
The HACCP feature provides the ability to get additional information such as
failure code, date of occurrence, min/max temperature (if applicable), and
duration of alarm condition.
To access previous failure codes, press and hold
the PROGRAM key for 5 seconds.
Use the UP and DOWN arrow keys to scroll
PROGRAM key to exit.
1.3.
SERVICE MENU
1.3.1 Entering the
configurat
The service menu can be accessed only during OFF mode.
Press the up/down keys
together
for 5 seconds to enter the menu.
controller doesn’t need actually any password to
the up arrow key the parameter list can be accessed directly
the parameter by pressing Up/do
Change the value by up/down keys. Pr
1.3.2 Parameter l
ist
The following table shows parameter factory settings for both Blast
and Shock Freezers (GBF).
NOTE:
Selecting a freezing cycle on a GBC unit
(Cabinet at 0°C, needle probe end cycle temperature at 3°C)
Blast ch
FAILURE CODE DETAILS
The HACCP feature provides the ability to get additional information such as
failure code, date of occurrence, min/max temperature (if applicable), and
To access previous failure codes, press and hold
the PROGRAM key for 5 seconds.
Use the UP and DOWN arrow keys to scroll
through the previous failure codes. Press the
SERVICE MENU
– CONFIGURATION
PARAMETER
configurat
ion parameter
The service menu can be accessed only during OFF mode.
for 5 seconds to enter the menu.
Label PA (password)
will be shown as first
controller doesn’t need actually any password to
configure the parameters. By pressing
the up arrow key the parameter list can be accessed directly
(first parameter is P0).
the parameter by pressing Up/do
wn keys. Select a
parameter by pressing
Change the value by up/down keys. Pr
ess again time key
to save and go back to the list.
ist
(factory setting)
The following table shows parameter factory settings for both Blast
Selecting a freezing cycle on a GBC unit
will run a normal chilling cycle
(Cabinet at 0°C, needle probe end cycle temperature at 3°C)
Blast ch
iller Service Manual
The HACCP feature provides the ability to get additional information such as
failure code, date of occurrence, min/max temperature (if applicable), and
To access previous failure codes, press and hold
through the previous failure codes. Press the
PARAMETER
will be shown as first
. The
configure the parameters. By pressing
(first parameter is P0).
Scroll
parameter by pressing
the time key
to save and go back to the list.
The following table shows parameter factory settings for both Blast
chillers units (GBC)
will run a normal chilling cycle