6159932180_09
71 / 7409/2019
FCC compliance (Class A)
This device complies with Part 15 of the FCC Rules. Any changes or modications not expressly
approved by the manufacturer could void the user’s authority to operate this device.
Operation is subject to the following two conditions:(1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause
undesired operation.
FCC Responsible party:
Name: Mark Johnson
Position: General Manager
Address: Chicago Pneumatic Tool Company
LLC 1815 Clubhouse Road Rock Hill
SC 29730
USA
Mobile: +1 800 624 4735
Email: mark.johnson@desouttertools.com
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to correct the interference
at his own expense.
Any changes or modications to this equipment not expressly approved by may cause, harmful
interference and void the FCC authorization to operate this equipment.
To Next Page
Loading...
Need help?
General
