To Next PageTo Next PageWhat to do if the Desoutter Controller says the motor is not detected?
If the Desoutter Controller indicates that the motor is not detected or the tool is not connected, check the cable and the connection between the screwdriver and the controller.
What to do if Desoutter Controller shows overload of the power stage?
If the Desoutter Controller shows an overload of the power stage of the torque measuring circuit (higher than 10 A for at least 600 ms), decrease the cycle rate and avoid reaching the stall torque of the motor.
What to do if Desoutter Controller shows bus undervoltage error?
If you see a 'Bus undervoltage + Vbus below 25 V for at least 3 s' error on your Desoutter Controller, verify that the controller is supplied with the correct voltage (110 / 230 VAC) according to your country's standards.
What to do if Desoutter Controller is adjusted on the hard joint when the joint is soft?
If the Desoutter Controller is adjusted for a "hard" joint when it should be a "soft" joint, turn off the controller, wait 5 seconds, and then turn it back on. After restarting, check the joint type setting.
What to do if Desoutter Controller is adjusted on the soft joint when it is a hard joint?
If the Desoutter Controller is adjusted for a "soft" joint when it should be a "hard" joint, turn off the controller, wait 5 seconds, and then turn it back on. After restarting, check the joint type setting.
How to fix no connection between main card and display on Desoutter Controller?
If there is no connection between the main card and the display on your Desoutter Controller, check that the flat jumper is well connected.
General| Brand | Desoutter |
|---|---|
| Model | ESP-CA 230 |
| Category | Controller |
| Language | English |
Safety warnings presented in English, French, Spanish, and German.
Safety warnings presented in Italian, Portuguese, Finnish, Swedish, Norwegian, Danish, Dutch, Greek, Chinese.
Safety warnings presented in Hungarian, Latvian, Polish, Czech, Slovak, Slovenian, Lithuanian, Russian.
General instructions for safe tool usage and handling.
Hazards associated with the work area and potential accidents.
Safety precautions related to electrical connections and usage.
Guidelines for operator's personal safety during tool operation.
Specific hazards associated with using the tool itself.
Procedures for maintaining and servicing the tool safely.
Describes the operational characteristics and specifications of the unit.
Provides physical dimensions of the controller unit.
Procedure for setting and changing the unit's password and language.
Configuration screen for screwdriver parameters like torque, joint, speed.
Screen for setting cycle parameters such as number of screws and rejection limits.
Screen for configuring print settings and descriptions.
Managing statistics and configuring audible feedback.
Details of the input pins and their functions for external control.
Details of the output pins and their functions for signaling status.
Table detailing the presence of hazardous substances in product components.
