6
KEYPAD FUNCTIONS
Figure No. 5
The membrane keypad is not to be operated with pointed objects (pencils,
pens, fingernails, etc). Damage to keypad resulting from this practice is NOT
covered under warranty.
ON I
With the indicator off, pressing this key will apply power to the scale and turn on the display.
OFF {
If the scale is on, pressing this key will remove power from the scale.
Î|Í
ZERO
This key is used to reset the display to zero up to the limit set during setup and calibration of
the scale. (See Setup and Calibration, USA)
UNITS
This key is used to change the weighing units to the alternate units of measurement if selected
during setup of the scale (WEIGHTING UNITS = 2 or 3). For example, with pounds displayed
(lb annunciator turned on) pressing this key will change the weighting units to kilograms (kg
annunciator will turn on). NOTE! This feature must be enabled during setup and calibration
for this key to be operational. This key is also used during setup and calibration to toggle
between the values.
~
PRINT
If an optional printer is connected to the scale, and the weight display is locked on the baby’s
weight, pressing this key will send the weight data to the printer. NOTE! This key is also used
during setup and calibration to display and then save the current setting.
NOTE! The scale will not respond to pressing the PRINT key unless the weight
display is stable and the Weight Lock annunciator is turned on.
To Next Page
Loading...
Need help?
General
