SET
9
The scale features 12 personal memory settings. This allows users to store and recall their own
height, age, gender and normal/athlete mode selection. Follow steps in the previous section
“Program Personal Data” to input your personal information into a memory location.
A. To Recall Settings from Memory for Body Fat and Total Body Water Estimation
You must have bare feet for estimation results. Remove your shoes and socks before proceed-
ing. Clean, slightly moist feet will provide the best results. Position your feet for maximum
contact with the metal electrodes on the platform.
1. Press the POWER button to turn the scale on.
2. Press the SET button to enter memory mode.
3. Press the or key to toggle between memory locations (1-12). Wait until the memory
code numbers stop flashing. Press either [ ] or [ ] once to enter review mode.
LCD will show last/previous measured records by sequence: F/W/M/B/BMI/KCAL/ in 3 cycles
then shut down. Note: The previous reading for that user number will appear after first use.)
[ ] [ ]
BODY FAT AND TOTAL BODY WATER ESTIMATING
OPERATION WITH USER MEMORY
4. When “0.0” appears on screen, step on the
scale with bare feet, positioning your feet evenly
on the scale platform with maximum contact
with the metal electrodes.
5. Stand still while the scale measures your
body weight first. Once your weight is
locked in the body impedance measurement
will start.
6. After the body impedance is measured, the scale will display the information as below.
This will repeat 3 times and then the scale will turn off.
B. TO TURN OFF THE SCALE
To turn the scale off, press the
ON/OFF key.
Or, if no key has been pressed for a few seconds, the scale turns off automatically.
% % %
%%%
To Next Page
Loading...
Need help?
General
