11
1. The clock and the temperature will be displayed toggle every 5 seconds as Fig.12
In the clock mode, press and hold <CLOCK> for 2 seconds to edit the clock, the hour will be
flashed, press <UP> and <DOWN> to increment or decrement the hour, press <SET> to confirm
hour setting and then minutes will be flashed, press <UP> and <DOWN> to increment or
decrement the minute, press <SET> to confirm whole clock setting and go back to the Clock mode.
In the clock mode, press and hold <SET> for 2 second to edit the unit, press <UP> and <DOWN>
to toggle the unit between LB/KG/ST. (EERPOM setting for no-unit/ 2-units/ 3-units) Press <SET>
again to confirm this setting and go back to clock mode.
1. “----” represents the weight is negative.
2. “ Err0” represents that the zero weight is not accurate.
3. “ Err1” represents instable weight measured.
4. “ Err2” represents overloaded.
5. “ Err3” represents that measurement error.
Clock Edit Mode
Unit Change Mode
Message Display
Advice for use and care
1. The glass platform will be slippery when it is wet. Keep dry.
2. Keep standing still during the course of weighing.
3. Treat the scale with care as it is a precise instrument.
4. Clean the scale with a damp cloth and avoid water getting inside the scale. DO NOT use
chemical/abrasive cleaning agents.
5. Keep the scale in cool place with dry air.
6. If scale fails to turn on, check whether battery is installed properly, or battery power is low.
Insert or replace new battery. Do not mix old and new batteries or different types of batteries
(alkaline, carbon zinc, rechargeable).
7. If there is error on display or the scale will not turn off for a long period of time, please take out
the battery for about 3 seconds, then install it again to correct error. If you cannot resolve the
problem, please contact Detecto Customer Service for consultation.
8. Do not use for commercial purposes.
To Next Page
Loading...
Need help?
General
