2. The base scale measures the weight. After a
stable weight is obtained, it asks the remote
to display the weight value (Fig.5).
1. During the base scale is OFF, when the user step onto the base scale, it wakes up the remote
display to have animation as in Fig.4.
3. The scale starts measuring the zero weight if the user steps off the scale. Then, the scale turns off.
2. If the base scale detects battery low, it will ask the remote to display “ Lo ” on LCD (Fig 3a).
If the battery low is in remote control itself, it will show “bAtt”(Fig 3b).
3. If the user steps onto the scale, the scale turns on and goes to Weighing Mode directly unless
it is the first time after the battery insertion or no valid zero weight is stored before. The scale
measures the zero weight and then sleep.
8
(Fig. 4: Weight trigger)
(Fig. 5: Weight obtained and locked)
(Fig. 6:User select)
(Fig. 3a) (Fig. 3b)
1. During the remote is in Clock mode, press [UP] or [DOWN] key to go into this
Memory Recall Mode, the user number will be flashed (Fig.6)
Weighing Mode
Memory Recall Mode
To Next Page
Loading...
Need help?
General
