9
(Fig. 7: User recall)
(Fig.8: weight
result display)
2. User press [UP] or [DOWN] to select the user memory and confirm the selection for idle
2 seconds operation. Then the user information will be shown (Fig.7)
3. User steps on the base scale and trigger the weight such as 4.2.
4. After the weight is stable and locked, the base scale transmits the value to the remote, the
remote displays among the weight, and the calorie for 2 times with each reading shown for
about 3 seconds (Fig.8).
5. If the user steps off the scale, the scale starts measuring the zero weight and asks the remote to
display running zero animation. (Fig.9).
(Fig.9: auto zero)
6. If the zero weight is different with previous zero value, the base scale tells the remote to display
“Err0” (Fig 10) and then go back to the clock mode.
(Fig.10: auto zero)
To Next Page
Loading...
Need help?
General
