Need help?Do you have a question about the Detector PC2003 and is the answer not in the manual?
Default measurement mode where the largest sensor movement is stored and compared to reference and tolerances.
Variation of Peak mode with an additional check to ensure sensor is working correctly.
Sensor's instantaneous position is directly compared to reference and tolerances.
Allows calibration of the sensor to a reference part on your machine after correct wiring and adjustment.
Defines the range of acceptable readings, beyond which the amplifier triggers relays to their fault states.
Allows masking of a measurement during material feed operation, isolating a short part without shutting down the machine.
Consists of offsetting a relay's fault state to the desired station, useful when bad parts are accessible.
Configures the number of consecutive measurements outside tolerance after which the machine will be shut down.
To Next Page
General