DEVI DEVIreg 850 User Manual

20
Installer Manual
Installation of dual system
The installation of a DEVIreg™ 850 with 2 roof systems or 2 ground systems has been
selected.
It is mandatory that no sensors or only sensors for System A are connected to the
the DEVIreg™ 850 before power up. Sensors for System B must be connected to the
DEVIreg™ 850 during the installation steps. Connection of the sensors during instal-
lation can either be done using a switch on the DIN-rail or just connect sensor bus of
System B to the already connected sensor bus of System A.
The rst installed system (System A) is using the output System A.
The second installed system (System B) is using the output System B.
If sensors for System A are not connected - do it now!
Press or wait…
Connect sensors:
System A
System is being scanned to nd type of connected
sensors…
System A
Scanning...
Select system type: Ground.
System type:
Ground
Wait until correct number of sensors for System A is
found.
1 Ground sensor
found. Accept?
Press when all sensors for System A are found…
System A is installed…
System A!
Installed
Connect sensors for System B.
Press or wait…
Connect sensors:
System B
System is being scanned to nd type of connected
sensors…
System B
Scanning...
Select system type.
System type:
Ground
Wait until correct number of sensors for System B is
found.
1 Ground sensor
found. Accept?

DEVI DEVIreg 850 Specifications

General

Brand	DEVI
Model	DEVIreg 850
Category	Controller
Language	English