DeVilbiss Intellipap DV5HH - Cleaning Procedures; Cleaning Cabinet and Filters; Cleaning Humidifier and Tubing; Cleaning Mask and Headgear




Toavoidelectricshock,alwaysunplugthepowercordfromthewalloutletpowersourcebeforecleaning.
CAUTION–Never rinse or place the device in water. Never allow liquids to get into or around any of the ports, switches or
air lter; doing so will result in product damage. If this occurs, do not use the device. Contact your equipment provider for
service.

1. Unplug the IntelliPAP from the power source. Wipe the cabinet with a clean, damp cloth every few days to keep the
cabinet dust free.
2. Allow the device to dry completely before plugging it into a power source.

Air-InletFilter
1. The air-inlet lter should be checked every 10 days and cleaned as necessary. The lter is located in the rear of the
device.
CAUTION–Proper lter function is important for the operation of the device and to protect the device from damage.
2. To clean, remove the dark outer foam lter from the frame.
3. Wash the lter in a solution of warm water and dishwashing detergent, and rinse with water. Allow the lter to dry
completely. If the lter (part #DV51D-602) is damaged, contact your equipment provider for a replacement.
4. Ensure the lter is completely dry before installation and use.
FineParticleFilter(Optional)
1. If you have an optional ne particle lter (part #DV51D-603), inspect this lter and replace it if it shows signs of dirt or
damage. Do not wash.
2. Install the ne particle lter behind the standard lter.
NOTE–If the ne particle lter is not installed rst according to the directions, the life of the lter will be reduced requiring
more frequent replacement.

WaterChamber-Humidierwaterchambershouldbecleaneddaily.
1. Press on the chamber release latch and pull out the water chamber from the cradle (Fig 4).
2. Separate the chamber halves by pressing forward on the chamber disassembly lever and lifting the lid of the
chamber (Fig 9).
3. Remove the sealing gasket from the chamber lid (Fig 10).
4. Wash the parts in a solution of warm water and mild diswashing detergent.
CAUTION–Hand wash only. Do not use any solutions that contain bleach, chlorine, alcohol, scented oils or other aromatic-
based ingredients to clean the humidier components or tubing. These solutions may reduce the life of the product.
5. Allow the parts to dry before reassembly.
CAUTION–Inspect the gasket seal before each use to ensure that it is properly seated in the groove around the entire
chamber.
HumidierCradle-Thehumidiercradleshouldbecleanedasneeded.
1. Turn off the heater and unplug from power source. Allow system to cool for at least 10 minutes.
2. Detach ow generator from the cradle; rst remove water chamber then fully depress the ow generator release
button to separate (Fig 4).
NOTE–Flow generator release button must be pressed completely to separate.
3. Use a soft, damp cloth to clean the surfaces of unit.

The air supply tubing should be cleaned daily. Remove the tubing from the device and mask. Use a mild detergent and
water to clean the inside of the tubing. Rinse the tubing and allow to air dry.

Clean the mask and headgear according to the manufacturer’s instructions.