Class II electrical protection-double insulated Type BF equipment-applied part
Data port input/output Standby-turns blower on/off
Next item on LCD display
Increase value on LCD display
Previous item on LCD display
Decrease value on LCD display
Attention, consult accompanying documents Heat
DC input: 12 VDC, center pin positive 100-240 VAC input 50/60 Hz
Locked
Unlocked
IPX1 Drip-proof, vertical Delay-starts the delay cycle
This device contains electrical and/or electronic equipment that must be recycled per EC Directive 2002/96/
EC-Waste Electrical & Electronic Equipment
• ElectricShockHazard – Do not use while bathing.
• ElectricShockHazard – Do not immerse this device into water or any other liquid.
• ElectricShockHazard – Do not attempt to open or remove the cabinet. There are no user-serviceable internal
components. If service is required, return the product to your home care provider. Opening or tampering with the
product will void the warranty.
• The DeVilbiss IntelliPAP should be used only with masks recommended by DeVilbiss, your physician or respiratory
therapist.
• To avoid rebreathing of exhaled air, do not use a CPAP mask unless the device is turned on and providing a supply
of air. Venting in the mask should never be blocked. When the device is turned on and providing a fresh supply of
air, exhaled air is ushed out of the mask vent. However, when the device is not operating, exhaled air may be
rebreathed. Rebreathing of exhaled air for longer than several minutes can in some circumstances lead to
suffocation. This warning applies to most CPAP devices.
• The DeVilbiss IntelliPAP is not a life support device and may stop operating with certain device faults or with a power
failure. It is intended to be used on spontaneously breathing individuals weighing 66 lbs/30 Kg or greater.
• To avoid electric shock, always unplug power cord from wall outlet power source when performing cleaning.
• Use only accessories recommended by DeVilbiss.
• Always remove the water chamber from the optional humidier cradle before lling.
• If water has spilled onto the humidier cradle or it has been submerged into water, unplug power cord from power
source immediately. Allow device to dry completely before use.
• Never block air openings of the humidier cradle or chamber. Do not insert objects into any openings or tubes.
• For proper operation, place system on a at, sturdy, level surface.
• The optional humidier is intended for single-patient use only.
• If the system is placed on the oor, do not position it where it may be stepped on when getting out of bed.
• The circular data port connector located on the back of the IntelliPAP is used to attach accessories to the device.
The connector must only be used with accessories approved for use by DeVilbiss. Do not attempt to attach any other
device to this connector as it may damage the CPAP or the accessory device.
To Next Page
Loading...
