• Never rinse or place the device in water. Never allow liquids to get into or around any of the ports, switches or air
lter; doing so will result in device damage. If this occurs, discontinue use and remove the power cord from the
power source. Allow the device to completely dry before use.
• Do not place the IntelliPAP where it can be knocked onto the oor or where the power cord may create a trip hazard.
• Only the DeVilbiss DV5 series Heated Humidier system is recommended for use with the IntelliPAP. Other
humidier systems may prevent the device from detecting snoring and may cause inappropriate pressure levels in
the mask.
• Empty and dry humidier water chamber before transporting.
The DeVilbiss IntelliPAP Model DV5 Series is intended for use in treating obstructive sleep apnea in patients 66 lbs/30 kg
and above.
Use on the advice and prescription of a licensed physician to help relieve the symptoms of dryness of the throat, nasal
passages and the mouth, which are common with positive airway pressure therapy. This is especially true in dry climates
and during the cold season when humidity in the air is typically lower than at other times.
Do not use IntelliPAP system if your upper airway has been bypassed.
1. Keypad/LCD Display (see Figure C)
2. Air Supply Port on Back
3. Air Supply Port on Bottom (for optional humidier)
4. Air Supply Port Plug
5. Heater Power Connector (for optional humidier)
6. AC Power Connector
7. DC Power Connector
8. Data Port
9. Power Cord (appropriate to your wall outlet) (not
shown)
10. Air Inlet Filter Opening
11 Connector Cover (not shown)
1. On/Off
2. Previous Item
3. Next Item
4. Delay
5. Decrease Value
6. Increase Value
7. Heater Power LED (for optional humidier)
Ask your equipment provider for information about other
DeVilbiss masks, equipment, and accessories.
1. Heater plate
2. Heater power connector
3. Storage compartment for connector cover (on
bottom)
4. Air supply port inlet
5. Air supply port outlet
6. Flow generator release button
7. Flow generator locking tabs
1. Chamber lid
2. Chamber base
3. Heat transfer plate (on bottom)
4. Sealing gasket
5. Water level indicators (front and sides)
6. Chamber release latch
7. Chamber disassembly lever
1. SmartLink
®
(optional)
1. Locate the air supply port and heater power connector on the bottom of the IntelliPAP device. Ensure that each
opening has the appropriate soft cover securely attached.
2. Place the IntelliPAP on a stable surface such as a nightstand or table. If you wish, you may also place the device on
the oor at the bedside, being careful to place the unit where it won’t be kicked or stepped on. Ensure that the air
inlet in the back of the device is not blocked by anything such as curtains or bedding.
NOTE
–Never place the IntelliPAP system on a soft surface such as a bed or couch during operation.
To Next Page
Loading...
