DeVilbiss IntelliPAP series User Manual

DeVilbiss IntelliPAP Series: Single Battery Connection
BATTERY POWER SOLUTIONS
Page 1 of 2 February 2017
DeVilbiss IntelliPAP series devices can be connected directly to the Freedom
TM
CPAP Battery using the DC power
pigtail cord and appropriate connector tip included in the Freedom
TM
CPAP Battery Kit. Please note IntelliPAP 2 series
devices will require the use of the 150W sine wave power inverter in conjunction with the Freedom
TM
CPAP Battery
Kit to complete the connection between the PAP device and the battery.
REQUIRED COMPONENTS
 Freedom
TM
CPAP Battery Kit
CONNECTION INSTRUCTIONS
 Plug the DC power pigtail cord into the DC OUT jack of the battery.
 Insert the connector tip with blue top labeled “J” into the DC power pigtail cord.
 Plug the DC power pigtail cord with “J” connector tip attached into the DC input port of the PAP device.
 Turn the PAP device on and it should begin functioning.
 The digital display screen will show the charge level of the battery. You may press the charge level indicator
button to illuminate this screen. It will stay illuminated for a few seconds at a time.
 When not in use disconnect all devices from the battery thus allowing the battery to completely shut down.

CONNECTOR TIP INSERTED
INTO PAP DC INPUT PORT
DC POWER PIGTAIL CORD

DC OUT JACK

OPTIONAL FREEDOM
TM
CPAP BATTERY CHARGING ACCESSORIES


 Auto Charge DC Cable {BPS DC.CABLE}: Used to charge the battery in a vehicle (vehicle must be running).


 150W Sine Wave Power Inverter {BPS 150 INVERTER}: Used to charge the battery in a vehicle (vehicle does not need to
be running) and allows the battery to power/charge other small electronic devices.


 SunPower 40W Solar Panel {BPS SP40}: Used to charge the battery using the power of the sun.

DeVilbiss IntelliPAP series Specifications

General

Data Storage	SD Card
Sound Level	26 dBA
Integrated Heated Humidifier	Optional
Auto On/Off	Yes
Noise Level	26 dBA
Therapy Modes	CPAP
Ramp Time	0-45 minutes
Starting Ramp Pressure	4 cm H2O
Power Supply	100 – 240 V AC, 50/60 Hz
Heated Humidification Levels	Adjustable
Model	IntelliPAP series

Summary

Single Battery Connection

Required Components

Lists the essential components needed for connecting the IntelliPAP device to the CPAP battery.

Connection Instructions

Detailed steps for connecting the PAP device to the battery and initiating operation.

Battery Charge Level Indicator

Explains how to view the battery's charge status on the digital display.

Power Management and Shutdown

Guidelines for disconnecting devices and ensuring the battery completely shuts down when not in use.

Dual Battery Connection

Required Components

Components needed for connecting two IntelliPAP devices or one device with a second battery.

Connection Instructions

Instructions for connecting the PAP device to two batteries and operating the system.

Optional Battery Charging Accessories

Details on accessories available for charging the Freedom CPAP battery using various power sources.