Network configuration 63
devolo dLAN pro 500 Wireless+
4.6.1 Create VLAN
The factory defaults have VLAN 1 configured with
VLAN ID 2. You can configure additional VLANs under
Create VLAN. In doing so, a VLAN (VLAN 1 to VLAN
15) has to be selected and a VLAN ID (1 to 4094) as-
signed. When creating VLANs, already assigned VLAN
IDs cannot be assigned a second time. Configured
VLANs are illustrated in the overview.
When configuring the VLANs and
the VLAN port settings, the configu-
ration interface of the
dLAN pro 500 Wireless+ should re-
main accessible, i.e. configurable. If
you ever "lock" yourself out in
spite of this, the device has to be re-
turned to the factory defaults by
being reset (see the Reset section).
4.6.2 Overview of configured VLANs
To delete a VLAN, first enable it and then confirm with
Delete. It is not possible to delete all VLANs; one
VLAN must remain configured.
An enabled VLAN configuration re-
quires at least one configured
VLAN, since otherwise the configu-
ration interface is no longer accessi-
ble and no connection of the port is
enabled.
To Next Page
Loading...
