Introduction 12
devolo Magic 1 LAN
1-1
2 The new devolo Magicadapter pairs automati-
cally so no button needs to be pressed. The LED
of this adapter now also flashes white.
After a short time, the flashing LED beco-
mes a steady white light. The devolo Magic
adapter has been successfully integrated
into your existing devolo Magic network.
For each pairing operation, only one addi-
tional devolo Magic adapter can be added
at a time.
You can find detailed information about in-
stalling devolo Magic adapters in Chapter
3.4 Connecting the devolo Magic 1 LAN.
Resetting a devolo Magic adapter or
removing it from a devolo Magic network
1 To remove a devolo Magic adapter from your
devolo Magic network and successfully restore
its entire configuration to the factory default
settings, press and hold the reset button longer
than 10 seconds.
2 Wait until the LED flashes white and then dis-
connect the devolo Magic adapter from the
mains supply.
Keep in mind that all settings that have al-
ready been made will be lost!
To Next Page
Loading...
