Initial use 22
devolo Magic 1 LAN
1-1
3.6 Removing the devolo Magic
adapter from a network
To remove a devolo Magic adapter from your net-
work and successfully restore its entire configurati-
on to the factory default settings, press the PLC/
reset button longer than 10 seconds. Wait until the
LED flashes white and then disconnect the adapter
from the mains supply.
Keep in mind that all settings that have already
been made will be lost!
To integrate the mains supply into another net-
work, proceed as described in Chapter 3.4.2 Addi-
tion – Expanding an existing network by adding
another devolo Magic adapter.
To Next Page
Loading...
