Initial use 26
devolo WiFi 6 Repeater 3000
b Crossband Repeating – changes the fre-
quency band to minimise interference.
5 In the last step, you get a summary of your set-
tings. Here, you can also view and print out a
QR code using your network's access data.
6 Then confirm this with Finish configuration
and wait until the set-up is complete.
Once the status bar is complete and the dot
as well as the arches in the Wi-Fi icon are lit
green, the WiFi 6 Repeater 3000 has been
successfully configured as a repeater.
For information about other possible device
settings, refer to Chapter 4 Network con-
figuration.
WiFi_6_Repeater_3000.book Seite 26 Freitag, 3. Juni 2022 2:06 14
To Next Page
Loading...
