27 Initial use
devolo WiFi 6 Repeater 3000
3.3.4Configuration as an access point
1 Click Install as access point.
Once the status bar is complete and the dot
in the Wi-Fi icon is lit green, the WiFi 6
Repeater 3000 has been successfully con-
figured as an access point.
For information about other possible device
settings, refer to Chapter 4 Network con-
figuration.
To ensure that the WiFi 6 Repeater 3000 has the
same Wi-Fi configuration as your Wi-Fi router, you
can apply the Wi-Fi access data using the Wi-Fi
Clone function. This can be enabled in different
ways:
Activating Wi-Fi Clone:
b Activating Wi-Fi Clone by pushing a button:
1 Press the Add button on the WiFi 6
Repeater 3000 for approximately 3 to 9 sec-
onds.
2 Press the WPS button on the Wi-Fi router with
the access data to be applied.
Now the WiFi 6 Repeater 3000 has the
same Wi-Fi configuration as your Wi-Fi rout-
er.
or
b Activating Wi-Fi Clone from the web interface.
More information about this function can be
found in Chapter WiFi Clone.
3.3.5Configuration as a repeater using
the Add button (WPS)
You can also configure the WiFi 6 Repeater 3000
as a repeater by pressing the Add button without
calling up the web interface.
1 Press the Add button on the WiFi 6
Repeater 3000 for approximately 1 to 3 sec-
onds to activate WPS.
2 Now, confirm the WPS activation on your Wi-
Fi router within 2 minutes or on another
access point within your WiFi network – e.g.
a by pressing the WPS button of your WiFi
router or the access point
a or by pressing the WPS function on the con-
figuration interface/app of the respective
device
For information about the WPS function/ac-
tivation of your Wi-Fi router or access point,
refer to the corresponding product docu-
mentation.
WiFi_6_Repeater_3000.book Seite 27 Freitag, 3. Juni 2022 2:06 14
To Next Page
Loading...
