DeWalt DC500 User Manual

11
ENGLISH
Emptying wet substances (fig. G)
• Place a suitable container under the drain plug
(4).
• Remove the drain plug.
• Allow ample time for the liquid to drain. Hold the
unit at an angle of approx. 10° to help the liquid
flow towards the drain plug.
• After the liquid has been drained, re-install the
drain plug.
• Dispose of the liquid with due care for the
environment.
Cleaning (fig. F & H)
• Unplug the tool from the mains and remove the
battery pack before cleaning the housing with a
soft cloth.
• Regularly clean the housing with a soft cloth.
Cleaning the tank (fig. F)
The tank should be cleaned after each use or when
switching substances during use.
• Empty the tank (3).
• Clean the tank using mild soap and a damp cloth.
• Dry the tank carefully using a soft cloth.
Cleaning the dust filter (fig. H)
The dust filter should be cleaned after each use.
If the filter is damaged or fails to operate properly,
it must be replaced.
• Remove the dust filter (19) by turning it counter-
clockwise and taking it off the suction opening (20).
• Shake off excess dust by tapping the filter into a
waste container.
• Depending on its condition, rinse the outside of
the filter under lukewarm running water.
• Secure the filter by placing it over the suction
opening and turning it clockwise.
• Do not wash the inside of the filter.
Let the filter dry thoroughly if the inside
becomes wet.
• Do not use a brush to clean the filter.
Cleaning the suction opening filter (fig. H)
The suction opening filter needs to be cleaned if the
tool is operated without the dust filter in place.
• Keeping the float valve (21) out of the way,
remove the filter from the suction opening (20).
• Rinse the filter under lukewarm running water.
• Dry the filter before putting it back in place.
• Clean the float valve (21) using a damp cloth.
Troubleshooting
If your tool seems not to operate properly, follow the
instructions below. If this does not solve the
problem, please contact your repair agent.
Shut-off feature engages
• Switch off the tool immediately.
• Empty the tank as described above.
• Clean the suction opening filter as described above.
• Remember to put the dust filter in place before
resuming work.
Unwanted tools and the environment
Take your tool to an authorized DEWALT repair
agent where it will be disposed of in an
environmentally safe way.
Rechargeable battery pack
A long life battery pack must be recharged when it
fails to produce sufficient power on jobs which were
easily done before. At the end of its technical life,
discard it with due care for our environment:
• Run the battery pack down completely, then
remove it from the tool.
• NiCd and NiMH cells are recyclable. Take them
to your dealer or a local recycling station.
The collected battery packs will be recycled or
disposed of properly.

DeWalt DC500 Specifications

General

Product color	Black, Yellow
Dust container type	-
Cleaning type	Dry&wet
Wet & Dry	Yes
Charging time	- h
Battery voltage	18 V
AC input voltage	230 V
Power consumption (typical)	300 W
Batteries included	No

Weight and Dimensions

Depth	390 mm
Width	225 mm
Height	360 mm
Weight	4600 g