To Next PageTo Next Page
Need help?Do you have a question about the DeWalt DCS498 and is the answer not in the manual?
General| Variable Speed | Yes |
|---|---|
| LED Light | Yes |
| Voltage | 20V |
| Battery Type | Li-Ion |
| No Load Speed | 0-3, 000 SPM |
Ensures safety by maintaining a clean, well-lit work area and keeping children and bystanders away.
Covers safe use of power tools regarding plugs, earthed surfaces, rain, cords, and extension cords.
Emphasizes staying alert, using PPE, preventing unintentional starting, and proper dress and balance.
Guidelines for proper tool use, maintenance, storage, and care to prevent accidents and ensure longevity.
Provides additional safety notes including eye protection and handling of dust.
Explains how to interpret charger indicator lights for battery status (Charging, Fully Charged, Hot/Cold Pack Delay).
Describes the delay mode for charging battery packs that are too hot or too cold.
Instructions for detaching the shear head assembly from the tool's motor.
Steps to remove the cutter blades, side knives, and spacers from the shear head.
Guidance on loosening, removing, and reinstalling the eccentric bearing assembly.
Procedure for installing side knives, side spacers, and center blades into the shear head.
Steps for correctly mounting the shear head assembly onto the drive motor.
Notes that self-lubricating bearings are used and recommends annual cleaning/inspection.
Instructions for cleaning air vents and the tool exterior, emphasizing eye protection and avoiding solvents.
