DeWalt DCST991 User Manual

ENGLISH
10
4. Install spindle plate
20
onto the spindle
21
, so the
double D shaped retaining nut
22
on the spindle sits
inside the base of the spindle plate.
5. Align the spindle plate hole and notch, insert a
screwdriver back into the hole and thread the new
spool housing counterclockwise. Securely tighten the
new spool housing onto the spindle
21
.
Fig. K
21
20
22
Replacing Guard (Fig.L–N)
An extended coverage guard is available (sold separately)
for extra coverage if desired. Use
DeWALT
replacement
guard Part Number 90624357.

WARNING: Never operate appliance
without guard firmly in place.
1. Remove the spool assembly as described in the
Replacing Spool Assembly section.
2. Remove the 4 guard screws
23
shown in FigureL.
Fig. L
23
23
3. Lift the guard off at an angle as shown in FigureM.
Fig. M
4. To attached a new guard, slide the
tab
24
of the new guard under the lip
25
of the motor
housing
5
, then lower the back of the guard into place
as shown in FigureN.
5. Replace and securely tighten the 4 guard screws
23
.
6. Replace the spool housing as described in the
Replacing Spool Assembly section.
Fig. N
24
25
Repairs
The charger and battery pack are notserviceable.

WARNING: To assure product
SAFETY and RELIABILITY, repairs, maintenance
and adjustment (including brush inspection and
replacement) should be performed by a
DeWALT
factory service center or a
DeWALT
authorized service
center. Always use identical replacementparts.
Register Online
Thank you for your purchase. Register your product nowfor:
• WARRANTY SERVICE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with yourproduct.
• CONFIRMATION OF OWNERSHIP: In case of
an insurance loss, such as fire, flood or theft, your
registration of ownership will serve as your proof
ofpurchase.
• FOR YOUR SAFETY: Registering your product will
allow us to contact you in the unlikely event a safety
notification is required under the Federal Consumer
SafetyAct.
Register online at www.dewalt.com/register.
Three Year Limited Warranty
DeWALT
will repair, without charge, any defects due to
faulty materials or workmanship for three years from the
date of purchase. This warranty does not cover part failure
due to normal wear or appliance abuse. For further detail
of warranty coverage and warranty repair information,
visit www.
DeWALT
.com or call 1–800–4-
DeWALT
(1–800–
433–9258). This warranty does not apply to accessories
or damage caused where repairs have been made or
attempted by others. This warranty gives you specific legal
rights and you may have other rights which vary in certain
states orprovinces.
In addition to the warranty,
DeWALT
appliances are covered
by our:

DeWalt DCST991 Specifications

General

Brand	DeWalt
Model	DCST991
Category	Trimmer
Language	English