DeWalt DCV585 - HEPA Filter

9
ENGLISH
compatible tools or through the use of an AirLock®
adapter(available from your local DeWALT supplier).
Refer to the Optional Accessories section for detail on
availableadapters.
NOTE: If using an adapter, ensure it is firmly attached to
the tool outlet before following the stepsbelow.
a. Ensure the collar on the AirLock® connector is in the
unlock position. (Refer to FigureE.) Align notches
17
on collar and AirLock® connector as shown for unlock
and lockpositions.
b. Push the AirLock® connector onto the adapter
connectorpoint.
c. Rotate the collar to the lockedposition.
NOTE: The ball bearings inside collar lock into slot
and secure the connection.The power tool is now
securely connected to the dustextractor.
Fig. E
25 26
1717
Dust Extractor Cleaning
To Empty Tank (Fig. A, F–H)
The sound of the motor changes and suction is reduced
when the tank isfull.
1. Press the two position switch
3
to the Off (O) position
and remove thebattery.
NOTE: Wait an adequate amount of time after shutting
the dust extractor off to allow dust to settle.
2. Unlatch the tank latches
4
.
Fig. F
4
3. Remove the dust extractor head
6
from thetank
16
.
Fig. G
6
16
4. Empty the contents of the tank into a suitablecontainer.
5. Clean or change HEPA filters
18
. Refer to HEPA Filter
section of thismanual.
6. Inspect machine for damage by foreign objects. Contact
the nearest DeWALT authorized service center for
replacement of damaged or missingparts.
7. Replace dust extractor head onto the tank.
NOTE: The dust extractor head only fits in one
orientation as shown in Fig G.
8. Latchall four latchessecurely.
NOTE: Inspect water sense probes
27
during dust
extractor cleaning. Water sense probes may become
contaminated during operation. If contamination is
present, clean water sense probes thoroughly with
damp cloth to remove any visible contamination.
Stacking Using the DeWALT TSTAK®
Stacking Latches (Fig. A)

WARNING: When stacking, always place the dust
extractor on the bottom of the stack.
The DEWALT TSTAK® stacking latches
10
allow for other
TSTAK® products to securely stack one on top of the other
for convenience and portability.
To use the TSTAK® stacking latches
10
, place a TSTAK®
compatible unit on top of the dust extractor and flip up the
two TSTAK® stacking latches so that they clip securely to the
bottom of the unit.
HEPA Filter

WARNING: The filters must always be in place
whilevacuuming.
HEPA Filter Care
The HEPA filters included with this dust extractor are long
life filters. To be effective in minimizing dust recirculation,
especially in lead paint (EPA RRP Rule) applications, the
filters MUST be installed correctly and be in goodcondition.