DeWalt DG series - Page 28

28

CODE POSSIBLE CAUSE POSSIBLE SOLUTION
7 Defective capacitor Contact a D
e WALT factory service center or a D e WALTauthorized
service center.
8 Faulty power cord Repair or replace cord
9 GFCI switch breaker tripped Depress and reset
10 Generator overloaded Reduce load
11 Faulty cords or equipment Check for damaged, bare or frayed wires on equipment. Replace.
12 Insufficient ventilation Move to adequate supply of fresh air
13
Faulty solenoid Contact a D e WALT factory service center or a D e WALTauthorized
service center.
14
Faulty idle control switch Contact a D e WALT factory service center or a D e WALTauthorized
service center.
15
Faulty windings in stator Contact a D e WALT factory service center or a D e WALTauthorized
service center.
16
Faulty circuit board Contact a D e WALT factory service center or a D e WALTauthorized
service center.
17
Faulty wire harness Contact a D e WALT factory service center or a D e WALTauthorized
service center.
18
Voltage selector in the 120V position Place the voltage selector to the 240V position when using a tool
that requires 240V.