8514-296-001 REV A page 42
Model Adjustable Final Spin
Range
T-300 60G to 100G
T-350 or T-350 SWD 60G to 200G
T-400 60G to 100G
T-450 or T-450 SWD 60G to 200G
T-600 60G to 100G
T-650 60G to 200G
T-750 or T-750 SWD 60G to 200G
T-900 60G to 100G
T-950 60G to 200G
T-1200 60G to 100G
T-1450 60G to 200G
2. “Delay Fill” is meant to be used in applications where the amount of available
water pressure is limited. In these cases, the washer may not be able to fill the
tub in sufficient time to allow for effective washing performance.
When the “Delay Fill” option is “On”, the water valves shall be turned on, the
washer shall agitate, but the cycle time shall be paused. The washer shall
continue in this state until the proper water level is reached. Once the proper
water level is reached, the cycle shall continue. A single selection of “On” or “Off”
shall apply to all baths in the cycle. The factory default setting is “Off”.
3. “Delay Spin” is meant to be used in applications where the amount of drain
capacity is limited. In these cases the washer cannot empty the tub in sufficient
time to allow for a spin cycle to occur.
When a time value (other than 0) is programmed for the “Delay Spin” option, the
end of each bath will be extended by the selected time. Therefore, extra time will
be allowed for the drain valve to be open and compensate for slow drain
capacity. The factory default setting is 0 seconds.
4. “Default Temp” allows the user to choose which water temperature (“Hot”,
“Warm”, or “Cold”) will be active during Idle mode. The customer can, of course,
choose other temperatures for the wash bath based on other options described
in this manual.
To Next Page
Loading...
Need help?
General
