Dexter Laundry A Series User Manual

96
8514-300-00
1 REV PR
Soluon The washer will not restart unl the power is
removed and re-applied.
COMM ERROR8 VFD
Communicaon
Fault
Condion This error is caused when the VFD reports a
frequency value that is out of range
Delay Delay me is 35 seconds
Acon Stop the machine and clear the cycle. Keep the
door locked unl the machine has stopped
moving and then unlock the door.
Soluon The washer will not restart unl the power is
removed and re-applied.
SECONDARY FUSE
ERROR
Factory program
error
Condion This error occurs when the fuse sengs for
the Slave/Secondary microprocessor have not
been set correctly during factory programming
Delay None
Acon When detected, the washer control shall not
be operaonal.
Soluon The control must be re-programmed with the
factory programming tool.
MAIN FUSE ERROR Factory program
error
Condion This error occurs when the fuse sengs for
the Master/Main microprocessor have not
been set correctly during factory programming
Delay None
Acon When detected, the washer control shall not
be operaonal.
Soluon The control must be re-programmed with the
factory programming tool.
DELAY Communicaon
loss
Condion This is an intermediate error code that displays
as the control is aempng to re-establish
communicaons with the variable frequency
drive. It is a condion of other specified Error
Codes (for example Comm Error6).
Delay 4 cycles of 10 seconds if during tumble poron
of cycle
4 cycles of 2 minutes if during spin poron of
cycle
Acon Prompt is displayed during each of the specified
10 second or 2-minute periods. Error condion
(such as Comm Error4) occurs, but Delay is
shown instead of specific Error Code. Acon
during this me is dependent on the specific
error code that caused it.
Soluon None. Either communicaon is re-established,
or the specific Error Code eventually occurs.
DRIVE STO VFD Safety
Torque Off Error
Condion This error occurs when the drive detects an
open circuit in both the S1 and S2 to +24V drive
jumper connecons.
Delay Occurs following the “DELAY” error (see
corresponding detail)
Acon Stop the machine and clear the cycle. Keep the
door locked unl the machine has stopped
moving and then unlock the door.

Dexter Laundry A Series Specifications

General

Brand	Dexter Laundry
Model	A Series
Category	Washer
Language	English