65
8514-300-001 REV PR
7.2.1 Starng A Vended Washer
1. Turn on power to the washer.
2. Load the laundry.
Place laundry into the cylinder and latch the door securely. Be sure laundry does not get
caught between the door gasket and tub front when closing the door. Maximum load is
the dry weight capacity listed in the specification sheet. Do not exceed the listed
capacity weight.
INFORMATION
To begin closing the door, the handle
must be in the horizontal position. After
moving the door to the closed position,
the handle must be turned down to the
vertical position in order to latch the door
for machine operation.
3. Select cycle temperature.
Select the appropriate cycle for the type of load being washed. Use the “UP” and
“DOWN” keys to change the cycle on the display to the desired cycle and press the
enter button to select.
4. Add washing chemicals.
Add low sudsing powdered detergent into the “DETERGENT” compartment of the
automatic dispenser on the top or front of the washer.
If liquid wash products are used in the “DETERGENT” compartment, they must be added
at the beginning of the wash cycle.
If desired, add fabric softener to the “FABRIC SOFTENER” compartment. Use the
amount of fabric softener as recommended by the manufacturer.
If the machine is set for pre-wash, washing products can be added to the round opening
of the dispenser or put in with the clothes when loading the washing machine.
If bleach is desired, DO NOT place into dispenser until the ADD BLEACH message is
displayed.
To Next Page
Loading...
Need help?
General
