98
8514-300-00
1 REV PR
Acon Stop the machine and clear the cycle. Keep the
door locked unl the machine has stopped
moving and then unlock the door.
Soluon Check VFD light code before turning off power.
Check the washer motor to ensure it turns
freely. Check the wiring for loose connecons to
the drive and motor. Measure the braking
resistor values. Check for damaged motor
wires. Check V-Belt tension and adjust to 1”
deflecon at center. Check braking resistors. If
problem reappears, contact your Dexter
representave.
DRIVE_OT VFD Ove
-Torque Condion This error occurs when too much torque is
detected on the VF drive
Delay Occurs following the “DELAY” error (see
corresponding detail)
Acon Stop the machine and clear the cycle. Keep the
door locked unl the machine has stopped
moving and then unlock the door.
Soluon Check VFD light code before turning off power.
Check the washer motor to ensure it turns
freely. Check the wiring for loose connecons to
the drive and motor. Measure the braking
resistor values. Check for damaged motor
wires. Check V-Belt tension and adjust to 1”
deflecon at center. Check braking resistors. If
problem reappears, contact your Dexter
representave.
DRIVE_ERROR_2 VFD Internal
Error
Condion This error occurs when there is an internal issue
with the VF Drive
Delay Occurs when too much slip of motor is detected
Acon Occurs following the “DELAY” error (see
corresponding detail)
Soluon Check VFD light code before turning off power.
Turn the power off to the washer. If no problem
is observed, turn on power to the washer and
test. If problem reappears, contact your Dexter
representave.
DRIVE_SLIP Motor Slip Error Condion The washer will not restart unl the power is
removed and re-applied.
Delay Occurs following the “DELAY” error (see
corresponding detail)
Acon Stop the machine and clear the cycle. Keep the
door locked unl the machine has stopped
moving and then unlock the door.
To Next Page
Loading...
Need help?
General
