8514-219-001 REV E PAGE 14
DRYER CONTROLLER FACTORY DEFAULT PROGRAM SETTINGS
DRY
CYCLE
COOL DOWN
TIME
(MINUTES)
TOTAL CYCLE
TIME
(MINUTES)
DRYING
TEMPERATURE
(
0
F) (
0
C)
DRYER LOAD
1 5 35 180 82 Towels, pads, heavy cotton
2 2 20 170 77 Sheets, blended materials
3 5 25 180 82 Cotton
4 2 20 130 54 Synthetic materials
5 2 25 175 79 Blended materials
DRYER FAULT CODES
FAULT# FAULT DESCRIPTION ACTION
F1
Shorted thermostat
sensor.
Dryer stops and “F1” flashes on the 4-digit display.
When short circuit on sensor input is removed, “LOAd”
appears on the 4-digit display and the remaining dry time
is reset.
F2
Open thermostat
sensor.
Dryer stops and “F2” flashes on the 4-digit display.
When a good sensor is connected to sensor input, “LOAd”
appears on the 4-digit display and the remaining dry time
is reset.
F3 EEPROM corrupted.
Dryer will not start and “F3” appears on the 4-digit
display. The power to the dryer must be cycled to reset
the controller. Fault should only occur when starting a
dry cycle.
F4 Heat relay on fault.
The drying temperature did not increase 1
0
F. in 5
minutes. “F4” will flash on the display and the dry cycle
will finish without calling for heat (energizing heat relay).
Opening the door or pressing the STOP touch pad switch
will reset the fault and clear the remaining time in the dry
cycle.
F5 Temperature fault.
The drying temperature is at least 25
0
F. above the
temperature setting. “F5” will flash on the 4-digit display
and the dry cycle will finish without calling for heat
(energizing the heat relay). The power to the dryer must
be cycled to reset the controller.
To Next Page
Loading...
Need help?
General
