43
8514-311-001 REV PR
3. Once the desired dry cycle is selected, press and release the START touch pad switch.
After the dryer controller START touch pad switch is pressed, the dryer cylinder will
start rotating and the two-digit total dry cycle time, along with a decimal point, will
appear on the dryer controller display.
The time shown on the dryer controller display will count down to the programmed
cool down time. At that time, the display will change from the decimal point and two-
digit number to a letter “C” and two digits.
The letter “C” represents the cool down portion of the dry cycle. The two digits
represent the amount of time remaining in the dry cycle. The two-digit time, shown on
the dryer controller display, will count down to zero.
When the time decrements to zero, the dryer controller display will flash the work
“donE” and the end of cycle tone will sound.
At that point, the wrinkle free cycle will automatically begin. This cycle will wait two
minutes, if the door is not opened or the STOP touch pad switch on the dryer
controller is not pressed, and then rotate the cylinder for 10 seconds and stop. This
two-minute of idle time and 10 seconds of tumble time will repeat a total of 10 times, at
which time the wrinkle free cycle stops. The cylinder will not rotate again until a new dry
cycle is started.
During the wrinkle free cycle, the gas valve will not be operated and there will be no
heat applied to the load. The word “donE” will also continue to flash and do so even
after the wrinkle free cycle is finished. When the dryer loading door is opened, or the
STOP touch pad switch is pressed, the word “donE” will change to the word “LOAd” on
the dryer controller display. The dryer will then be ready for another dry cycle.
During the dry cycle, either pressing the STOP touch pad switch on the dryer
controller or opening the dryer loading door will stop the dry cycle and not clear it. If
you press the STOP touch pad switch on the controller and then open the dryer loading
door, the dry cycle will not be cleared. However, if you open (or open and close) the
dryer loading door and then press the STOP touch pad switch on the dryer controller,
the present dry cycle will be cleared, and the word “LOAd” will appear on the dryer
controller display.
There are two jumpers and one push button on the component side of the dryer
controller printed circuit board.
The jumper located at the lower right side of the circuit board controls whether the
controller display shows and operates in the Fahrenheit or Celsius mode. This jumper is
labeled as TEMP SELECT and has three pins. The bottom and middle pins are for Celsius
and the top and middle pins are for Fahrenheit, which is indicated by the letter C for
Celsius and the letter F for Fahrenheit.
To Next Page
Loading...
Need help?
General
