Clothes Door Latch Adjustment ..........58
Door Switch Removal and Installation .58
Installation of Clothes Door Window and
Gasket ........................................58
High Limit Thermostat Locations and
Functions ....................................58
Pressure Regulator Adjustment ..........59
Coin Acceptor Removal .....................59
Coin Switch Adjustment ....................59
Heat Sensor .....................................59
Electronic Control Diagnostic Lights ....60
Electronic Control Test Cycle ..............60
Electronic Control Removal ................60
Membrane Switch Replacement .........60
Temperature Sensor Testing ..............60
Temperature Testing .........................60
Temperature Sensor Removal ............61
Upper Front Panel Removal ...............61
Lower Front Panel Removal ...............61
Final Drive Belt Replacement .............61
Motor Drive Belt Replacement ............61
Tumbler Pulley Removal and Installation
..................................................61
Intermediate Pulley and Tension Arm
Removal .....................................61
Tension Arm Support Assembly Adjustment
..................................................62
Motor and Blower Assemly Removal
and Installation ...........................62
Air Flow Switch Operation and Adjustment
..................................................62
Ignition Transformer Fuse ..................62
Ignition Control Transformer ..............62
Electronic Ignition Module .................62
Spark Electrode Assembly Function ....62
Ignition System Function and Sequence 63
Ignition System Checkout ..................64
Spark Electrode Assembly Removal ....64
Gas Valve & Manifold Removal ...........64
Main Burner Orice Removal ..............64
Main Burner Removal ........................64
Recirculation Chamber Inspection ......64
Cylinder Removal ..............................64
Adjustment of Cylinder Assembly
with Front Panel Removed ............64
Tumbler Through Bolt Access Cover ...65
Bearing Housing Removal ..................65
Section 6:
Troubleshooting
Electronic Control Diagnostic Lights 68 & 69
Electronic Control Test Cycle .............. 70
Trouble Shooting Fault Codes ............71
Troubleshooting Tips .................... 72-75
Section 7:
Parts Data
Cabinet Group ............................. 78-81
Control, Electronic ...................82 & 83
Hinge Plate ......................................84
Door Switch ....................................84
Bearing Housing Group .....................86
Tumbler Assembly Group ..................87
Burner Housing Group ..............88 & 89
Rear View ................................90 & 91
Rear Panel & Cover Group ......... 92 & 93
Control Assembly Group, Rear ...94 & 95
Coin Handling Group .........................96
Wiring Group .................................... 97
Section 8:
Maintenance
Regular Required Maintenance ......... 102
Section 9:
Voltage Conversion
Convert a Dual Voltage Stack Dryer from
120V to 208-240V with Neutral Wire
Only ............................... 104 & 105
Section 10:
50 hz Models
Specications ................................. 109
Wiring Schematic Explained 50Hz ..........
.......................................110 & 111
Parts ....................................... 112-117
Schematic ...................................... 118
Diagram......................................... 119
11
Part # 8533-090-001 7/21