Why Dexter Laundry T600 Washer water drains slowly?
If water is draining slowly from your Dexter Laundry Washer, inspect the hoses and drain valve for blockages. Clean them if necessary and ensure they are adequately sized. Also, check the building drains for any blockages.
Why Dexter Laundry T600 tumbles in one direction?
If your Dexter Laundry Washer only tumbles in one direction, you can check the following: * **VFD:** Remove the top cover and note if the power light or fault lights are displayed. Check the front control for related codes and refer to the fault code section for more information. * **Wiring:** Inspect the yellow enable wires from the main relay PCB and at the VFD.
What to do if Dexter Laundry Washer starts and does not operate?
If your Dexter Laundry Washer starts but doesn't operate, check that the yellow enable wires from relay PCB P13 & motor P14 to the VFD are connected and advancing through the cycle. Check the fault code on the VFD before removing power from the drive. Also, check the orange P-15 wire for a signal from the door switches.
How to fix water level too high in Dexter Laundry T600?
If the water level is too high in your Dexter Laundry Washer, check the pressure switch hose for blockages. Also, check for the pressure switch opening circuit across the terminals. Replace the switch if the contacts do not open.
Why Dexter Laundry T600 machine does not stop?
If your Dexter Laundry Washer doesn't stop, it could be due to: * **Main PCB:** The main PCB controls the time cycle at the end of the cycle. * **Braking Resistors:** Check the braking resistors for continuity and verify the ohms resistance by Molex.
General| Model | T600 |
|---|---|
| Type | Front Load Washer |
| Capacity | 20 lb (9.1 kg) |
| Control Type | Microprocessor |
| Phase | 3 |
| Width | 27.5 in |
| Depth | 32.13" (816 mm) |
To Next Page
