To Next Page

To Previous Page

38 39

Part # 8533-080-001 12/15 Part # 8533-080-001 12/15

B. Based on your internet browser the le needs to be saved as “AllUser.xml”. Depending

on your Internet browser you may need to retrieve the le from

your “Downloads” folder, which is locater under “Computer”.

Note: The newly created programing le may have changed from the proper “AllUsers.xml”.

Machine programming will not occur using a different le name than “AllUser.xml”. Any

extra extension names will require the le to be renamed back to “AllUser.xml” for the

machine to recognize the le.

7) To save the Programming File to a USB Drive:

A. Move or Copy the “AllUser.xml” le from your computer onto a USB drive.

B. Based on your computer and internet browser, this le may be found in your “Down

loads” folder, which is located under the “Computer” area.

Note: The “AllUser.xml” le size is small, nearly any capacity USB drive will do.

8) Program Your Machines Using the USB Drive

CAUTION!!! Be sure that any loose keys or other items that are connected to the USB de-

vice are removed from the USB stick to prevent any possible metal contact

with the control board.

A. Insert the USB drive containing the “AllUser.xml” le into the Dexter machines you

wish to program. The control will scroll “…………” while identifying the program on

the USB. Once identied, the display will scroll “INSTALL USER FILE FROM USB”. At

this prompt press the green start button on the front panel.

B. The machine will scroll “TO INSTALL – PRESS START”. At this prompt, press the

green “Start” again.

C. Once the program is uploaded successfully the control will scroll “DONE REMOVE

USB”. The USB drive can be safely removed at this point.

Note: All Dexter equipment (washers and dryers) featuring DexterLive controls can be

programmed using this le once the equipment has been congured.

Dexter Laundry WCAD Series Parts & Service Manual

Other manuals for Dexter Laundry WCAD Series