Dexter Laundry WCAD Series Parts & Service Manual

48 49
Part # 8533-080-001 12/15 Part # 8533-080-001 12/15
Plus Cycle Options:
The Plus Cycle options allow for the user to prompt the customer for varying vend prices based on addi-
tional wash baths chosen. In general, the user can program the additional wash baths in a similar manner
to what was described in the “Cycles” Options section.
It also allows the user to return the programmable values to the factory default setting. No plus cycle op-
tions are active using the factory default. To reset all values in the Plus Cycles option to factory default,
press “Enter” when the “DEFAULT” prompt is shown. Press “Enter” again when the “RESET” prompt is
shown to conrm the action.
Figure 6, shown below, shows the next level options for Plus Cycle Options:
Pre-Wash:
If the user programs a “CYCLE TIME” for Pre-Wash other then 0 (“NO CYCLE”), the feature becomes active.
However, the customer will not be prompted to pay an additional vend price for Pre-Wash unless the user
programs the Price to a value other then 0 (“FREE”).
With the Pre-Wash feature active, an additional bath and, optionally, an additional spin, will occur before
the standard Wash bath described in the Cycles Options section.
With the Pre-Wash feature active and a Price value programmed, the customer will be prompted to add
additional coins if they wish to purchase the Pre-Wash feature. This will occur after they have entered coins
to meet the Base Vend price. If the customer does not meet the vend price of the Pre-Wash feature, the
prompt will time out and the Pre-Wash bath will not occur.
Extend Wash:
If the user programs an “EXTEND TIME” for Extend Wash other then 0, the feature becomes active. How-
ever, the customer will not be prompted to pay an additional vend price for Extend Wash unless the user
programs the Price to a value other then 0 (“FREE”).
With the Extend Wash feature active, the standard Wash bath described in the Cycles section will be ex-
tended for the additional time selected.
With the Extend Wash feature active and a Price value programmed, the customer will be prompted to add
additional coins if they wish to purchase the Extend Wash feature. This will occur after they have pressed
the “Start” button to begin the normal Wash cycle. If the customer does not meet the vend price of the
Extend Wash feature, the prompt will time out and the additional time will not be added to the Wash bath.
Extra Rinse:
If the user programs a “CYCLE TIME” for Extra Rinse other then 0 (“NO CYCLE”), the feature becomes ac-
tive. However, the customer will not be prompted to pay an additional vend price for Extra Rinse unless the
user programs the Price to a value other then 0 (“FREE”).
With the Extra Rinse feature active, an additional bath and, optionally, an additional spin, will occur after
the standard Final Rinse bath described in the Cycles Options section.
With the Extra Rinse feature active and a Price value programmed, the customer will be prompted to add
additional coins if they wish to purchase the Extra Rinse feature. This prompt will occur during the standard
Final Rinse bath. If the customer does not meet the vend price of the Extra Rinse feature, the prompt will
time out and the Extra Rinse bath will not occur.

Dexter Laundry WCAD Series Specifications

General

Brand	Dexter Laundry
Model	WCAD Series
Category	Washer
Language	English