Coin Washer Cycle Parameter Ranges
The range of each cycle parameter is shown below:
Bath Cycle Time “ct”
0 to 15 minutes for Prewash, Rinse1 and Rinse 3 to 15 minutes for Wash and Final Rinse.
For the baths that can, if the time is set to zero, then that bath will be eliminated from the
cycle.
Bath Water Temperature “t”
HH – hot, CH – warm, CC – cold, EE – no water. The owner can set the bath default.
For the wash bath, the default is over ridden for that cycle by the customer when the
temperature is selected.
Bath Water Level “L”
LO – low The owner can change the displayed value, but for a coinwasher only LO will be
put into the cycle.
Bath Delay Fill “dF”
The selections are “d” for delay the bath time until water level is reached or “t” for
decrement bath time during the fi ll.
Bath Spin Time “S”
0 to 10 minutes for Prewash, Wash, Rinse1 and Rinse2 1 to 10 minutes for Final Spin.
Bath “IS”
The owner can change the displayed value, but for a coin washer only 0 will be put into the
cycle.
5
Part # 8533-073-001 11/11
To Next Page
Loading...
Need help?
General
