6
136
RAID
Step 3: Configure RAID in the RAID BIOS
When the system powers-up and all drives have been detected, the
NVRAID BIOS status message screen will appear. Press the <F10>
key to enter the utility. The utility allows you to build a RAID system
on Serial ATA drives and Parallel ATA drives. Press the <Ctrl> and
<X> keys to exit the RAID BIOS.
Step 4: Install the RAID Driver
If you are in the process of installing Windows
®
XP or Windows
®
2000 on RAID configured drives, you will need the provided RAID
driver floppy diskette. If you are installing the driver on existing
Windows
®
XP or Windows
®
2000, install the corresponding RAID
driver that is in the provided CD.
Installing NVRAID Driver While in the Process of Installing Win-
dows
®
XP or Windows
®
2000
The steps below will instruct you on installing the RAID driver while
in the process of installing Windows
®
XP or Windows
®
2000 on
RAID configured drives.
1. Start Windows Setup by booting from the installation CD.
2. Press <F6> when prompted at the beginning of Windows
setup.
3. Now the following steps are extremely crucial because there
are 2 essential files that must be installed here. Press <S> to
select “Specify Additional Device”.
4. At this point you will be prompted to insert a floppy disk
containing the RAID driver. Insert the provided RAID driver
diskette.
5. Locate for the drive where you inserted the diskette then select
“NVIDIA nForce4 ATA Controller”. Press <Enter> to install the
driver.
6. Now press <S> again to specify another device.
To Next Page
Loading...
