4000 Controllers Section 1: Safety
Controller Operations Manual Rev C 6
Section 1: Safety
Following is a list of safety symbols and their meanings, which are found throughout this manual. Pay attention to these symbols
where they appear in the manual.
Caution or Warning! Denotes possible personal injury and/or damage to the equipment.
Caution or Warning! Denotes possible personal injury and/or equipment damage due to electrical hazard.
NOTE: (Will be followed by a brief comment or explanation.)
ESD protection should be worn when servicing internal printed circuit boards.
After service to the equipment is completed, replace all protective devices such as grounding cables and covers before operating
the equipment.
It is extremely important to:
• Clean up all spills with the appropriate conditioner immediately and dispose of all waste according to local and state regulations.
• Wear safety glasses and protective clothing, including gloves, when handling all inks and conditioners.
• Store inks and conditioners under the recommended conditions found on the SDS (Safety Data Sheet).
!
!
To Next Page
Loading...
Need help?
General
