Diamondback 910IC - Page 12

910Ic Owner’s Manual
13
 Locate connector B-17 exiting the
bottom of the handlebar assembly
(B-21).
 Connect B-17 to wire harness
connector G-7, taking care to ensure
the connection is firm.
 Remove handlebar assembly endcap fixing screw (B-20) from the
handlebar assembly endcap (B-1).
 Insert the handlebar assembly endcap (B-1) into the bottom of the
handlebar assembly (B-21).
 Reinstall the handlebar assembly endcap fixing screw (B-20) through the
base of the handlebar assembly (B-21) to secure the endcap.