What to do if DieHard Battery Charger won't turn on?
If your DieHard Battery Charger isn't turning on, check the AC outlet for an open fuse or circuit breaker. Also, inspect the power cord and any extension cords for loose connections. The battery itself may also be defective, so have it checked.
What to do if DieHard Battery Charger shows F04?
If your DieHard Battery Charger is displaying the error code F04, it means the battery is connected backwards. Unplug the charger and reverse the connections to the battery.
Why does my DieHard 28.71326 have a short start cycle?
A short or no start cycle when cranking the engine with your DieHard Battery Charger can occur if the cranking draws more current than the Engine Start Rate, if you don't wait 3 minutes between cranks, if the clamps aren't making a good connection, if the AC cord is loose, if there's no power at the receptacle, if the charger is overheated or if the battery is severely discharged. To resolve this: * Ensure you wait 3 minutes between cranks to allow cooling. * Check for good connections at the battery and frame. * Check the power cord and extension cord for loose connections. * Check the AC outlet for an open fuse or circuit breaker. * Ensure the charger vents are not blocked. * For a severely discharged battery, use the 3012A Boost setting for a few minutes.
What to do if DieHard Battery Charger shows F05?
If your DieHard Battery Charger is showing error code F05, it could be due to a drain on the battery, or the battery itself might be bad. First, ensure there are no loads on the battery and remove any if present. If there are no loads, have the battery checked or replaced.
What to do if DieHard 28.71326 shows F03?
If your DieHard Battery Charger displays error code F03, it may be because you're trying to charge a large battery or bank of batteries on too low of a current setting. Try again with a higher current setting or have the battery checked or replaced.
What to do if DieHard 28.71326 shows F06?
If your DieHard Battery Charger displays error code F06, the charger has automatically shut the current off because it detected that the battery may be getting too hot. Have the battery checked or replaced.
What to do if DieHard 28.71326 Battery Charger shows F01?
If your DieHard Battery Charger is displaying the error code F01, the battery could be bad. Have it checked or replaced.
What to do if DieHard Battery Charger shows F02?
If your DieHard Battery Charger is showing error code F02, it means the battery could not be desulfated. Have it checked or replaced.
Critical warning about explosive gases from batteries during operation.
Guidelines for personal protection when working with batteries.
Instructions for charging a battery while installed in a vehicle.
Instructions for charging a battery removed from a vehicle.
List of error codes and their meanings.
Common problems and their solutions.
General| Brand | DieHard |
|---|---|
| Model | 28.71326 |
| Category | Battery Charger |
| Language | English |
To Next Page
