39
Connecting the 2 Speed Harness to a Skid Steer Loader
The drive unit is connected to the two speed controller (mounted in the cab) and connection can be done using
either of the two options below:
• Direct connection to the loader attachment service plug (optional 8-pin or 14-pin adaptor). In this option
depending what service plug the host machine is tted with (8-pin or 14-pin), the motor harness part
number DM-000021 will take an 8-pin adaptor lead part number DM-000032 or 14-pin terminated
adaptor lead part number EC-000241. The 14-pin plug will have to be assembled & pinout congured to
suit the customer’s machine.
OR
• Connecting using the Plug 'n Go Kit part number DM-000034 comprising a cab controller, power lead
and 6m (20') boom extension harness (optional).
Operation of the 2 Speed
• The 2 Speed Planetary drive unit range is manufactured using either EATON VIS or Linde hydraulic
motors.
• The speed controller (mounted in the cab) is only used on the Eaton powered drive units. This allows the
operator to select the optimum speed required for drilling, core barrelling or applying screw pylons into
the terrain.
• HIGH Speed is Low Torque - LOW Speed is High Torque (see the torque chart supplied with your drive
unit to read, output RPM and corresponding torque at an applied hydraulic pressure).
12 2 Speed Installations-Electrics
To Next Page
Loading...
