Command descriptions status
ConnectPort® LTS Command Reference
166
status
Purpose
Displays the current list of sessions. The “status” command displays the status of outgoing
connections (connections made by “connect,” “rlogin,” or “telnet” commands). In contrast, the
“display” command displays real-time information about a device, while the “info” command displays
statistical information about a device over time. Typically, the “status” command is used to determine
which sessions to close.
Required permissions
For products with two or more users, permissions must be set to “set permissions status=read” or
“set permissions status=rw” to use this command. See "set permissions" for details on setting user
permissions for commands.
Syntax
status
Example
#> status
Connection: 3 From: 10.8.109.8
Connection not associated with any sessions.
See also
n connect
n close for information on ending a connection.
n display
n info
n rlogin
n telnet
n who
To Next Page
Loading...
Need help?
General