Digi ConnectPort LTS 8 Command Reference

Command descriptions telnet
ConnectPort® LTS Command Reference
167
telnet
Purpose
Used to make an outgoing Telnet connection, also known as a session.
Required permissions
For products with two or more users, permissions must be set to “set permissions telnet=execute” to
use this command. See "set permissions" for details on setting user permissions for commands.
Syntax
telnet ipaddress [ tcp port ]
Options
ipaddress
The IP address of the host to which you want make a Telnet connection.
tcp port
The TCP port assigned the Telnet application on the remote system. The default is 23, the port
typically used for Telnet.
Examples
Establish a Telnet session using an IP Address
In this example, the telnet command establishes a Telnet session using an IP address. The default
TCP port (23) is used.
#> telnet 192.192.150.28
Establish a Telnet session to a device server port from the LAN
In this example, a user on the LAN initiates a Telnet connection to port 4 on a device server.
#> telnet 192.192.150.28 2004
See also
n rlogin
n connect
n close
n status

Digi ConnectPort LTS 8 Specifications

General

Brand	Digi
Model	ConnectPort LTS 8
Category	Server
Language	English