Command descriptions set autoconnect
ConnectPort® LTS Command Reference
55
Examples
Set autoconnect on with trigger
This example shows setting autoconnect to connect to the TCP port (2101) of the network IP
destination when data arrives on the serial port.
#> set autoconnect state=on trigger=data
ipaddress=10.0.0.1 ipport=2101
Allow outgoing data that is either unacknowledged or less than maximum segment size
#> set autoconnect port=1 nodelay=on
See also
n revert
n set network
n set serial
n set tcpserial
n show
To Next Page
Loading...
